Pixhawk2.1 (Edison Carrier Board)+ Here 2 GNSS (M8N)

HX4-06057

Get Started on your road to Autonomy! This Kit contains the following items

1. The Cube.... the brains behind the opperation.
2. A standard carrier board.(no compatible with Intel Edison Chip)
3. 1 Power Brick (two power bricks can be fiter for redundant power.)
4. Cable set that allows you to connect to your old Telemetry module, GPS, and sensors
5. Detailed includes(Cables for accessories are JST to DF13 cables which are compatible with old pixhawk accessories, such as Telemetry, Power Brick or GPS):

   PIXHAWK2.1  Here 2 * 1

   PIXHAWK2.1 Carrier * 1

   POWER Brick Mini * 1

   SD Card(inserted in Cube) * 1

   TELEM Cable * 2

   POWER Cable * 1

   I2C Cable * 1

   BUZZER Cable * 1

   MICRO USB Cable * 1

   GPS1 Cable(with saftey switch) * 1

   GPS2 Cable * 1

   I2C Splitter * 1

   Mounting Screws(M2.5*8) * 4

   3M Double Sided Foam Tapes

    

   For detailed usage of Intel Edison Chip

   Please refer to :

   http://ardupilot.org/dev/docs/intel-edison.html

   Get Started on your road to Autonomy! This Kit contains the following items

   1. The Cube.... the brains behind the opperation.
   2. A full carrier board.
   3. 1 Power Brick (two power bricks can be fiter for redundant power.)
   4. Cable set that allows you to connect to your old Telemetry module, GPS, and sensors
   5. Here GNSS.

   Detailed includes (Cables for accessories are JST to DF13 cables which are compatible with old pixhawk accessories, such as Telemetry, Power Brick or GPS):

   Here GNSS * 1

   PIXHAWK2.1 Cube * 1

   PIXHAWK2.1 Full Carrier Board * 1 (compatible with Intel Edison)

   POWER Brick Mini * 1

   SD Card(inserted in Cube) * 1

   TELEM Cable * 2

   POWER Cable * 1

   I2C Cable * 1

   BUZZER Cable * 1

   MICRO USB Cable * 1

   GPS1 Cable(with saftey switch) * 1

   GPS2 Cable * 1

   I2C Splitter * 1

   Mounting Screws(M2.5*8) * 4

   3M Double Sided Foam Tapes